Table of Contents
Advertisement
MAIN MENU SELECTION - "ALARMS/SHUTDOWNS" SCREEN
The
following
are
the
selection keys:
·
[Clear Alarms] - Selecting this key will clear all
alarms and/or shutdowns from this screen.
·
[Alarms/Shutdown History] - A full screen of
failures is stored, along with the Last Fail
Date/Time of the failure. The stored data shows
on the "Alarms/Shutdowns History" screen. The
data is saved, even if there is a power outage.
To resume normal operation it will be necessary to go
through the following steps:
1.
Correct the conditions causing the alarm.
MAIN MENU SELECTION - "ALARMS/SHUTDOWNS HISTORY" SCREEN
®
FRICK
QUANTUM™ ACUair
OPERATION
"Alarms/Shutdowns"
screen
®
CONTROL PANEL
2.
To clear or reset the "Alarms/Shutdowns" screen
and turn off any alarm annunciation device, from
the screen press the [Clear Alarms] key. This
will also clear the ALARM or SHUTDOWN
message from the "Operating Status" screen.
3.
If the conditions causing the alarm have not been
corrected or a new fault has occurred, a new
ALARM or SHUTDOWN message will appear.
The Alarms/Shutdowns history screen keeps a
record of the alarms and shutdowns. This
information will help troubleshoot persistent
operational problems.
Refer to the "Alarms/Shutdowns Message" section for a
list of all the possible alarms.
S90-500 O
Page 11
Advertisement
Table of Contents
Need help?
Do you have a question about the Quantum ACUair and is the answer not in the manual?
Questions and answers