Advertisement
1. Fasten standoffs onto metal pems configuration (A) or configuration (B) of enclosure depending on the
sub-assembly module (Fig. 4, pg. 5).
2. Position sub-assembly module over corresponding standoffs and secure module into enclosure with
four (4) pan head screws supplied (Fig. 4a, pg. 5).
3. Refer to the Trove2 Installation Guides and individual Sub-Assembly Installation Guides for the
following models: ACM4(CB), LINQ2, LINQ8PD(CB), MOM5, PD4UL(CB), PD8UL(CB),
PD16W(CB), PDS8(CB), ACMS8(CB), VR6 for further installation instructions.
Sub-Assembly Position Chart for the Following Models:
Sub-Assembly
Module
ACM8(CB)
ACMS8(CB)
LINQ2**
LINQ8PD(CB)
ACM4(CB)
MOM5
PD4UL(CB)
PD8UL(CB)
PD16W(CB)
PDS8(CB)
VR6
* Top left position (A) is usually reserved for Altronix power
supplies, but can also be used for sub-assemblies (Fig. 4).
** LINQ2 can be installed when utilizing
eFlow power supply/charger boards.
Note: TM2 (Mercury/Lenel) and TV2 (HID/VertX)
Trove2 backplane models allow for additional
sub-assembly mounting positions on the right side.
Fig. 4a
Pan Head
Screw
Sub Assembly
Sub-Assembly
Installation Instructions for Trove2:
Mounting
Mounting
Position
First, Second,
Third & Fourth
on Left
Top Edge
Second, Third
& Fourth on
Left
Pem
Standoff
Enclosure
A *
C
B
A
A
B
A
B
A
B
Fig. 4
C
- 5 -
Advertisement
