Altronix PD16WCB Quick Start Manual

These power distribution modules converts a single AC input into sixteen (16) individually fuse
or PTC protected outputs.

Power Distribution Module Configuration Reference Chart:

Altronix
Model Number
PD16W
PD16WCB
*Total output is limited by the total output of UL Listed power supply employed.
Input:
• 24VAC or 28VAC up to 12.5 amp
or 12VDC or 24VDC up to 10 amp.

Fuse Ratings:

• Fuses are rated @ 3.5A/250V .
1. Mount sub-assembly power distribution module in desired location/enclosure.
2. Connect the desired UL Listed power supply output of a suitable rating to terminals marked [INPUT] (Fig. 1a, pg. 2).
3. Measure output voltage before connecting devices. This helps avoid potential damage.
All terminals with common suffix P 1P, 2P..." are same polarity.
5. Connect each device to terminal pairs 1 to 16, marked [1P-1N thru 16P - 16N] (Fig. 1, pg. 2).
For DC applications "N" terminals are negative and "P" terminals are positive. Note: Observe polarity.
WARNING: To reduce the risk of fire or electric shock, do not expose the unit to rain or
moisture. This installation should be made by qualified service personnel and should conform to
all local codes and in accordance with the National Electrical Code.
For continuous protection against fire hazard, replace fuses only with the same type and rating.
PD16W, PD16WCB
Power Distribution Modules
-- 16 3.5 amp
16 -- 2.5 amp

Specifications:

Installation Instructions:

Overview:

10 amp 12.5 amp
10 amp 12.5 amp

Visual Indicators:

• Power output LED indicator.

Board Dimensions (approximate):

6"H x 5.875"W x .95"D (PD16W, PD16WCB)