Advertisement
1. Fasten standoffs onto metal pems configuration (A) or configuration (B) of enclosure depending on the
sub-assembly module (Fig. 2, pg. 3).
2. Position sub-assembly module over corresponding standoffs and secure module into enclosure with four (4)
pan head screws supplied (Fig. 2a, pg. 3).
3. Refer to the Trove1 Installation Guides and individual Sub-Assembly Installation Guides for the
following models: ACM4(CB), LINQ2, LINQ8PD(CB), MOM5, PD4UL(CB), PD8UL(CB), PD16W(CB),
PDS8(CB), ACMS8(CB), VR6 for further installation instructions.
Sub-Assembly Position Chart for the Following Models:
Sub-Assembly
Module
ACM8(CB)
ACMS8(CB)
LINQ2**
LINQ8PD(CB)
ACM4(CB)
MOM5
PD4UL(CB)
PD8UL(CB)
PD16W(CB)
PDS8(CB)
VR6
* Position (A) is usually reserved for Altronix power supplies,
but can also be used for sub-assemblies (Fig. 2).
** LINQ2 can be installed when utilizing
eFlow power supply/charger boards.
Fig. 2a
Pan Head
Screw
Sub Assembly
Sub-Assembly
Installation Instructions for Trove1:
Mounting
Mounting
Position
Top Left
Top Edge
Bottom Left
Pem
Standoff
Enclosure
A *
C
B
C
A
B
Fig. 2
- 3 -
Advertisement
