Siemens interranger DPS300 Instructional Manual page 30

Transducer Assembly
5. Procure a length of corrosion resistant conduit for suspending the transducer and skimmer guard
assembly such that the transducer face will be immersed 3 to 6 cm into the clarifier water.
Siemens suggests ¾" standard stainless steel pipe (schedule 10) cut with ¾" NTP threads.
6. To facilitate running the transducer cable through the conduit, fish a wire through from the hinge
end first.
7. Slide the 2-inch hose clamp over the
knuckle of the Skimmer Guard.
8. Run the transducer cable through the
skimmer guard; starting at the
transducer coupling, through the
conduit and out the hinge.
9. Pull the cable through until the
transducer is pulled up to the
mounting coupling.
10. Screw the transducer into the
mounting coupling and tighten.
11. Run the transducer cable from the hinge out the conduit
coupling.
12. Pull cable taught insuring that the cable will not
get pinched in the hinge.
13. Run the transducer cable through the
boot and customer conduit.
14. Slide the boot over the end of the customer
conduit, and screw the conduit into the coupling.
15. Slide the boot over the hinge.
The transducer and skimmer guard are now ready for installation.
Location and Installation
If a Mounting Assembly is used ...
If a Siemens mounting assembly is being used to mount the Skimmer Guard
assembly, first refer to Optional Mounting Assembly on page 25.
For Location
For recommendations as to the preferred point of installation of the transducer and
skimmer guard, refer to Application Planning on page 16.
InterRanger DPS300
customer conduit
boot
skimmer guard
transducer
30
1" hose clamp
2" hose clamp
2"
bushing
7ML19981BC01