Inserting Sim Card - PROEMION CanLink GSM 5 Series Preliminary Manual

PROEMION GMBH, Phone: +49 661 9490-600, Fax: -666, info@proemion.com, proemion.com
4.4

Inserting SIM card

In order to establish a link to your GSM network provider, you need to insert the
SIM card into the device. The SIM card holder is located inside the enclosure.
NOTICE
► Do not open the housing if CANlink GSM / UMTS 5xxx is switched on.
► Switch off the power supply to CANlink GSM / UMTS 5xxx first and then
disconnect the power supply connector.
The maximum torque for fixing the enclosure screws is 1.5 Nm.
► When opening/closing the enclosure, do not exceed this value.
► Only open the enclosure in a clean environment so that no dust or fluid can get
inside.
► Do not touch the PCB nor the components mounted on the PCB, they may be
damaged by electrostatic discharge (ESD).
Scratches and bending can cause damage to the SIM card.
► Do not bend the card nor touch the contacts.
The SIM card's operating temperature may differ from the device specifications.
► Contact the SIM card provider for the admissible temperature range.
To insert the SIM card, proceed as described below.
1. Switch off the power supply to the device, then disconnect the power
supply connector.
2. Remove the enclosure screws using a T15 screwdriver.
CANlink GSM / UMTS 5xxx Device Manual
PRELIMINARY 4 Getting started
52