Gps Antenna; Connect Can Gateway And Pc - PROEMION CanLink GSM 5 Series Preliminary Manual

FCC requirements
PROEMION GMBH, Phone: +49 661 9490-600, Fax: -666, info@proemion.com, proemion.com
According to FCC requirements, the antenna gain, including cable loss, must not
exceed the limits of 7.3 dBi in the 850 MHz Cellular band and 12.7 dBi in the PCS
1900 MHz band (CANlink GSM 5xxx devices) or 7.2 dBi in the 850 MHz cellular
band and 3.5 dBi in the PCS 1900 MHz band respectively (CANlink UMTS 5xxx
devices).
4.2.1.2

GPS antenna

NOTICE
► Use only active GPS antennas with LNA, gain max. 25 dBi, voltage 3 V DC,
current max. 30mA.
1. Make sure that the device's power supply is switched off.
2. Connect the antenna's SMA connector to the device's GPS connector.
To maximize the performance of the GPS receiver, mount the GPS antenna in a
place where it is level with the local geographic horizon and has full view of the sky
above. If you are using separate GSM/UMTS and GPS antennas, mounting them
at least 2 meters away from each other will also help to improve the GPS
performance.
There are different GPS antennas available for CANlink GSM / UMTS 5xxx. For a
list of suitable antennas see chapter 1.2.3 Software and accessories or contact our
sales team: sales@proemion.com
4.2.2

Connect CAN gateway and PC

After connecting the antennas, establish a connection to a PC via a gateway
device, in our case a CANview USB.
Before connecting the CANview USB to the PC, you need to install the device
driver manually from the RM System Tools CD if you have not done so
already.
1. Access the following storage location on the CD or in the CD storage
folder:
Devices\\RM CANview USB\\Drivers\\Your operating system
CANlink GSM / UMTS 5xxx Device Manual
PRELIMINARY 4 Getting started
36