Capacity Control; Scheduled Operation - Hitachi NEXT Series Instruction Manual

Oil-free rotary screw air compressor
Hide thumbs Also See for NEXT Series:
Table of Contents

Advertisement

3. OPERATING PROCEDURE [How to Use the Liquid Crystal Display (LCD)]
3

Capacity control

This function sets the pressures and times for capacity
control. Two different combinations (P1 and P2) of
pressures can be used. Item number with dot " . " can
be select from LCD monitor. Item number with a dash "
- " can be selected from digital monitor. (
1. Type: Indicates the setting data for capacity control
 ① Type of capacity control (Cannot be changed from
LCD monitor)
Fixed speed type
I: Indicates the standard, 2-step control.
IP: Indicates the motor stop/restart capacity control
to "I".
Vtype
VA: Indicates motor stop/restart capacity control is
effective.
VB: Indicates motor stop/restart capacity control is
canceled.
 ② Pressure setting (Cannot be changed from LCD
monitor)
S-1: Indicates pressure setting 1
S-2: Indicates pressure setting 2
EXT: Indicates external pressure setting
S-A : Indicates pressure setting switches by set time
on ⑥.
 ③ Option condition and setting.
NUL: Indicates no option.
2. - 3. OPTION: Used for options.
4. - 6. Pressure Setting: ④ Indicates cut-in, cut-out
and target pressure setting 1 and 2 can be confirmed.
Target means target pressure for ECOMODE
7. TIME LIMIT (Fixed speed type only)
⑤ Indicates the time limit of load/unload one-cycle
time for ECOMODE. Load/unload one-cycle time
must be 30 seconds or more. (
22
3.4)
3.4.8)
8. TIME: ⑥ Can set the time to use pressure setting 2.
When set the value properly, ② is indicated in " S-A". If
the start and stop time is set at same value, pressure
setting 2 is not in use and ② is indicated in S-1. And
pressure setting 1 and 2 can be changed by external
switch. Set the F018 on digital monitor "2". (
and 3.4.7)
IMPORTANT
The settings can be memorized while the air compressor
is stopped.
4

Scheduled Operation

Allows a standard daily scheduling operation.
This illustration indicates a scheduling operation from 7:00 to
20:00. TIME field indicates a current time of 19:07.
1. MODE:
OFF
Operates without a schedule.
Schedule
Operates according to a daily 24- hour calendar.
(1) to (5) : Five Start/Stop Time Patterns
・ START : Starting Time
・ STOP : Stopping Time
・ Y or N : Starts or Stops as scheduled
IMPORTANT
When the schedule is selected, the AUTO light comes ON
(glowing) if the time setting is valid and ON (blinking) if the
time setting is invalid. The settings can be memorized
while the air compressor is stopped.
2.-3. RECORD1, 2 : This function allows for the
capability to record data over a desired time in a day.
To view the recorded data, refer to "5. Operation data
display" on the next page.
3.4.2

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents