Used for basic settings as well
as other various settings in
combination with the LCD monitor.
● ALARM light (green): Blinks if
an alarm failure occurs.
Press this button to stop the air compressor.
The air compressor will stop after removing the
condensate from the air end.
※This stop button is effective while a stand alone operation.
Activates or deactivates a
remote start/stop operation
locally or on the instrument
EMERGENCY STOP button
Stops for emergency.
SELECT/WIDE Button/Light (Yellow)
Press to confirm the measurement
values, shutdown history, and
setting status. (
To s e t t h e E C O M O D E [ E n e rg y
saving mode] (Fixed speed type
only), hold down the SELECT/WIDE
button for at least 7 seconds. The
light blinks and ECOMODE is set.
3. OPERATING PROCEDURE [Instrument Panel]
RUNNING MODE Light
● POWER light (yellow): Lights up when the main power
is turned on.
● REMOTE light (green):
ON (glowing) when the REMOTE button is pressed in
order to activate a remote operation.
ON (blinking) when an external remote-operation-
activation switch has been turned on in order to
activate a remote operation. (
● LOAD light (yellow): ON (glowing) when the air
compressor is loading.
● AUTO START light (green):
ON (glowing) while the air compressor is in a stop due
t o a n A U T O o p e r a t i o n , l e a d / l a g o p e r a t i o n , o r
ON (blinking) while the air compressor is in a stop due
to a restartable instantaneous power interruption.
● SHUTDOWN light (red): Blinks if a shutdown failure
Stops the compressor
immediately without unloading.
Stops the compressor in normal
The compressor stops running
after removing the condensate
from the air end. (
Starts the air compressor.
The START light turns ON while
air compressor is running.
UNLOAD STOP Button