S.o.f.t. Lateral Support Option; Swingaway Lateral One-Finger Release - Sunrise Medical Whitmyer Directions For Use Manual

1. Attach swingaway lateral bracket(s) (Fig. 1, D) to S.O.F.T. base plate assembly (Fig. 1, C) using bolts
(Fig. 1, A) and washers (Fig. 1, B). Tighten bolts securely.
2. Refer to Fig. 2. Loosen bolts (Fig. 2, A) and clamp splitball (Fig. 2, B) between the lateral mount collar
halves (Fig. 2, C) and tighten. Do not securely tighten collar halves until fitting to client to allow for
adjustment of ballrod.
3. Slide collar cover (Fig. 2, D) off pad collar onto curved ballrod (Fig. 2, E).
4. Loosen collar bolts (Fig. 2, F). Loosening the collar bolts just to the point where the ball slides in is
easier than taking the collar halves completely apart.
5. Clamp collar halves (Fig. 2, G) evenly on ball. See page 13.
6.To attach lateral ballrod and pad. See page 17, steps 5-9.
To open, grasp swingaway lateral latch as shown. Push with thumb and pull with fore-finger. To close,
push lateral ballrod into place until latch snaps shut.
Head Support Instructions

S.O.F.T. Lateral Support Option

A
B
D
C
Fig. 1

Swingaway Lateral One-Finger Release

www.jay-seating.com
F
E
G
D
B
A
C
Fig. 2
www.sunrisemedical.com | 15