Contoured Cradle Lateral Support Option - Sunrise Medical Whitmyer Directions For Use Manual

1. Attach swingaway lateral bracket(s) (Fig. 1, D) to Contoured Cradle lateral support interface plate
(Fig. 1, C) using bolts (Fig. 1, A) and washers (Fig. 1, B).
2. Refer to Fig. 3. Tighten bolts (Fig. 3, A) securely. Swingaway lateral bracket may be bolted either left or
right or used in unilateral or bilateral configurations.
3. Refer to Fig. 2. Remove bolts (Fig. 2, A) and discard bottom collar half of pad (Fig. 2, B).
4. Evenly clamp the horizontal ball (Fig. 2, C) between the pad collar half (Fig. 2, D) and Contoured
Cradle lateral support interface (Fig. 2, E).
5. Refer to Fig. 4. Loosen bolts (Fig. 4, A) and clamp splitball (Fig. 4, B) between the lateral mount collar
halves (Fig. 4, C) and tighten. Do not securely tighten collar halves until fitting to client to allow for
adjustment of ballrod.
6. Slide collar cover (Fig. 4, G) off pad collar onto curved ballrod (Fig. 4, E).
7. Loosen collar bolts (Fig. 4, D). Loosening the collar bolts just to the point where the ball slides in is
easier than taking the collar halves completely apart.
8. Clamp collar halves (Fig. 4, H) evenly on ball (Fig. 4, F). See page 13.
9. Slide collar cover (Fig. 4, G) onto collar (Fig. 4, H).
D
Fig. 1
Head Support Instructions

Contoured Cradle Lateral Support Option

A
A
E
B
C
A
Fig. 3
www.jay-seating.com
D
C
B
H
C
www.sunrisemedical.com | 13
Fig. 2
D
F
E
G
A
C
B
Fig. 4