Table of Contents
Advertisement
Available languages
Available languages
8
GROWTH PLATE ADJUSTMENT:
(Allows growth of the back to the width of the chair.)
Tools: 5/32 Allen wrench
1. Loosen the two fasteners that secure each
growth plate.(A)
2. Slide the growth plate (B) to the desired position.
3. Tighten the two fasteners (A) for each growth
plate to secure in the desired position.
LATERAL BRACKET INSTALLATION Figure 16
Tools: 5/32 Allen wrench
1. Remove existing growth plate (A) assemblies
from back assembly, set aside mounting hard-
ware.
2. Install right side lateral assembly (B) and
growth plate (A) with longer mounting hardware
(C), leave fasteners loose. Repeat procedure for
left side.
3. Slide growth plate / lateral assembly to desired
position for both left and right assemblies.
4. Tighten mounting hardware.
LATERAL BRACKET VERTICAL ADJUSTMENT Figure 17
Tools: 5/32 Allen wrench
1. Remove growth plate (A) and lateral assemblies
(B) from back assembly.
2. Adjust lateral to desired vertical position.
3. Follow procedure for lateral bracket installation.
XT200005 Rev. B
I n s t a l l a t i o n
A
Figure 14
B
Figure 15
C
B
A
Figure 16
B
A
Figure 17
R e m o v a l a n d R e p l a c e m e n t
REMOVAL AND REPLACEMENT
Following installation and adjustment, the J2 Plus Back can be easily removed from the
wheelchair if necessary. Simply remove both left and right retaining pins. Rotate the top
of the Back shell forward and lift the Back up and out of the wheelchair. To re-install the
Back, lower the back lower connectors to fit over the pivot pins. Rotate the top of the
Back shell rearwards, ensuring both the left and right side upper connectors have fitted
into their respective back shell receiver. Secure the back shell by installing both the left
and right retaining pins through the side plate, upper connector and back shell receiver.
NOTE– The Back angle will not change when removed and re-installed on the wheelchair.
9
XT200005 Rev. B
Advertisement
Chapters
Table of Contents
