Dynamic Anterior Support | Dfs 2 - Sunrise Medical Whitmyer Directions For Use Manual

Installation:
Using a e/ah" Allen ® wrench: Loosen the rear
1
occipital screwball
Fig-1 (A), adjust up or down to provide slot
access.
2 Remove the bolt and washer (B) from the
DFS 2
mounting plate.
3 Fit the mounting plate to the front of the
occipital mount
slot as shown. Plate can be mounted above or
below occipital pad.
4 Replace the bolt and washer and tighten (B).
Forehead Strap Adjustment:
5 Using a t/ds" Allen wrench: Loosen the guide
rods adjustment screw Fig-2 (F), and slide both
guide rods evenly to desired diameter.
6 Locate neoprene strap (D) in desired position
on forehead.
7 Slide guide rods through clamp until front of
neoprene strap is approximately q/s" from
plastic guide support (E). Strap must fit snuggly
on forehead. Fig-3 (H)
C
FIG-1
Patent Pending
28 | Head Support Instructions
DYNAMIC ANTERIOR SUPPORT | DFS 2 >>>
D
C
DFS 2
HCPC Code:
Part Number
www.jay-seating.com
8 Re-Tighten guide rod adjustment screw (F) to
hold position.
9 Guide rods may be trimmed to 1" limiting
rearward protrusion.
Vinyl caps should be removed prior to trimming
and then reinstalled. Fig-3(I)
10 Re-adjust forehead strap as necessary.
Downward Stop Angle Adjustment:
11 Using a t/ds" Allen wrench loosen the angle
adjustment clamp screws Fig-1 (C).
12 Insert an Allen wrench into the exposed hole
Fig-2 (G) on the silver angle adjustment pivot
and rotate until the forehead pad and guide
rods are at the desired angle.
13 Re-tighten the angle adjustment clamp screws
and check
all settings.
Notice:
Fasteners and DFS 2 adjustment should be checked
prior to each use. Neoprene Strap must be replaced at
the first signs of wear or loss of tension.
E
1"
F
G
FIG-2
K0108
SINGLE PAD
SYSTEMS
DFSQ30 (small)
DFSQ10 (Large)
www.sunrisemedical.com
q/s"
H
FIG-3
I
S.O.F.T. SYSTEM
DFSQ3 (small)
DFSQ1 (Large)