Ex500 Part Names; Dimensions; Installation - SMC Networks EX500 Series Instruction Manual

EX500 Part Names

No. Name
1 Communication Connect with CC-Link line by using the accessory
connector bus adapter
2 Power supply connector Supply power for output devices such as solenoid
valve, for input devices such as sensor, and for
controlling GW/SI by using power supply connector
cable. ( Note1 )
3 Communication port A
( COM A )
4 Communication port B
( COM B )
Connect SI unit ( manifold valve ) or Input unit by
using branch cable with M12 connectors. ( Note1 )
5 Communication port C
( COM C )
6 Communication port D
( COM D )
Display Display the power supply status and communication
7
status with PLC. ( Note2 )
8 Station number switch Set station numbers and transmission speed by
protective cover using the switches under this cover. ( Note2 )
Note1: For wiring method, refer to subsection "Wiring" ( page 9 ) of section "EX500" in this
manual.
Note2: For display and setting method, refer to subsection "Display/Switch Setting" ( page 18 )
of section "EX500" in this manual.
6
Accessory
Application
. ( Note1 )
Dimensions ( unit: mm )
EX500 body
Bus adapter ( accessory )
18.5
OUT
IN
Installation ( unit: mm )
Thread mounting
Secure at four positions with screws with head diameter of 5.2 or more and thread
length of 15mm or more.
4 M5
Tightening torque :
*
(1.5 0.2 ) Nm
Cutout Dimensions for Mounting (Tolerance : 0.2)
L
L
160
136
unit side
148
7