SpectraLink 6300 MCU: T1 Remote Module Installation: SpectraLink 6000 System
16
Network clocked T1 facilities
If the T1 facilities are Network Clocked, one T1 Remote Module must
be designated as the Master Clock Source. Connect the
this T1 Remote Module to
Note, this shelf must also be designated as the Master Clock in the
system configuration.
Connect T1 facilities
Connect the RJ48C jack from the
and
ports on the T1 Remote Module. Port
DS1 B
through 7 on the remote module at the far end. Port
through 12.
The following diagram shows the T1 Remote Module connections at
the LOCAL site.
port
on the Intershelf Junction Panel.
AUX
A
port at the local end to the
CSU
PN: 1725-36126-001_K.doc
port on
Sync IN
DS1 A
controls slots 3
A
controls slots 8
B
Need help?
Do you have a question about the SpectraLink 6300 MCU and is the answer not in the manual?