Installing The Aileron Servos - Seagull Models Decathlon 60-85cc-3D Assembly Manual

4.

INSTALLING THE AILERON SERVOS

1.
2.
Minimum servo spec.
Torque : 250 oz-in (18 kg-cm) @ 4.8V;
333 oz-in (24 kg-cm) @ 6.0V
Because the size of servos differ, you
may need to adjust the size of the precut
opening in the mount. The notch in the
sides of the mount allow the servo lead to
pass through.
Epoxy.
Ailerons control horn
Place the servo between the mounting
blocks and space it from the hatch. Use
a pencil to mark the mounting hole loca-
tions on the blocks.
Use drill bit in a pin vise to drill the mout-
ing holes in the blocks.
3.
4.
5.
Apply 2-3 drops of thin C/A to each of
the mounting holes. Allow the C/A to
cure without using accelerator.
6.
C/A glue
40mm
1.5mm
7