Seagull Models Decathlon 60-85cc-3D Assembly Manual page 11

9.
10.
Set the flap control at the transmitter to
the down flap position. Adjust the flap
travel at the transmitter until it matches
the control throws listed in this manual.
11.
Trim the flap linkage cover using a hobby
knife and hobby scissors.
3x10mm
12.
13.
Fit the flap linkage cover into position.
Check the operation of the flap to make
sure the cover does not interfere with the
flap linkage.
14.
Use canopy glue to attach the cover to the
wing. Use low-tack tape to keep the cover
in position until the adhesive fully cures.
11