Red Pitaya HAMlab 80-10 10W User Manual page 68

5.6.1. Power button
Momentarily pressing power button (1) will turn the HAMlab ON. It normally takes 30s from the button
press until the HAMlab is ready to be used. Once HAMlab is ON, holding the power button pressed will
cause the proper shut down of the device. Blue LED indication on the power button indicates that device
is turned on.
Note
In case that system halts and becomes unresponsive, device can be turned off by holding power button
for a few seconds / until the blue LED is turned off.
5.6.2. SDR
5.6.2.1. Microphone connector (RJ45)
The HAMlab 80-10 10W front microphone connector (2) can support Kenwood KMC 30 electret
microphone or compatible types.
Front panel view microphone pinout
Pin
1
2
3
4
5
6
7
8
The manual is made on the site
Red Pitaya HAMlab Documentation
5.6. Front panel controls and connections
Function
NC
8V DC
Ground
PTT
Ground
MIC
NC
NC
https://trcvr.ru 68