Hamlab 80-10 10W Specifications; Sdr Specifications - Red Pitaya HAMlab 80-10 10W User Manual

4.1.1. Highlights
Architecture:
Band coverage:
Transmit power:
Wideband Frequency Coverage:
Connection to PC:
Software:
Phones and MIC connection:
Secondary Rx and Tx channel:
CW key and paddle input:
4.1.2. Receiver Specifications
Architecture:
ADC Sampling Rate:
ADC Resolution:
Wideband Frequency Coverage:
MDS (min. detectable signal):
Preamp OFF at 14MHz
Preamp +15dB at 14MHz
Preamp +30dB at 50MHz
Preselectors:
4.1.3. Transmitter Specifications
Architecture:
TX DAC Sampling Rate:
TX DAC Resolution:
RF Output Power:
Transmitter Frequency Range:
Low Pass PA Filter Bands:
Emission Modes Types:
Harmonic Radiation:
3rd-Order IMD:
Cooling:
Microphone connector:
Microphone impedance:
4.1.4. General Specifications
Antenna Connector:
Antenna Impedance:
RF Output Power:
Maximum Interconnect Cable
Length Ethernet:
Power connector:
The manual is made on the site
Red Pitaya HAMlab Documentation

4. HAMlab 80-10 10W Specifications

4.1. SDR specifications

direct sampling / internal high performance 14-bit A/D and D/A 125 Msps
converters (no sound card required)
All band receiver with 5 bands transmitter (80, 40, 20, 10 m)
up to 10 W
25 kHz - 62.25 MHz
1 Gbit Ethernet or WIFI connection
Power SDR, HDSPR, Gqrx, GNU Radio, GNU Radio Companion and Pothos
available on the front panel
available through back panel BNC connectors (RX2 IN, XVTX)
available through front panel jack connector
Direct Digital Sampling
125Msps
14 bits
25 kHz - 62.25 MHz
MDS (typ)@ 500Hz BW
-113dBm
-130dBm
-135dBm
More MDS measurements.
Available as add-on module (coming soon)
User can also connect own preselectors/filters to back panel BNC
connectors (RX1 IN, RX1 OUT)
Direct Digital Up-conversion
125 Msps
14 bits
up to 10 W CW and SSB at @ 13.8 V input voltage (max. 15 V)
80 - 10 m (amateur bands only)
80 m / 40 m / 20 m / 10 m (possibility to changed it to any range 1.8 - 50
MHz)
not limited by HAMlab hw, depending on 3rd party SDR software used
better than -45 dB
better than -35 dB below PEP @ 14.2 MHz 10 Watts PEP
copper heat spreader
RJ45
600 ohm unbalanced
SO-239 UHF or BNC back panel connector (ANT1, ANT2)
50 Ohm Unbalanced
up to 10 W CW and SSB at 13.8 V input voltage (max. 15 V)
100 meters (328 feet), Category 5 cable
PowerPole
https://trcvr.ru 56