Red Pitaya HAMlab 80-10 10W User Manual page 30

3. Open the Terminal and check the available disks with "df -h". Our SD card is 4GB and mounted
to /dev/sdb
4. Unmount the SD card with "umount /dev/sdbN" (make sure you replace N with the right
number).
5. Write the image to the SD card with the following command : dd if=image_file of=/dev/sdb
bs=1M
Note
Replace the red_pitaya_image_file with the name of the unzipped Red Pitaya SD Card Image
and /dev/device_name is replaced with the path to the SD Card, usually it will be /dev/sdb.
6. Wait until the process has finished.
1. Insert SD card into your PC or SD card reader.
The manual is made on the site
Red Pitaya HAMlab Documentation
2.7.3. MacOS
https://trcvr.ru 30