Red Pitaya HAMlab 80-10 10W User Manual page 24

2.5.3.2. Access Point mode
This type of the connection is ideal if there is no LAN or WiFi network. HAMlab will simply create its own
WiFi network on which users PC/Laptop or Tablet can be connected. Access Point mode is arranged via
Network Manager application where you give the name to your HAMlab network and enable it. Since
Access Point mode is enabled via Network Manager application this means that first you need to use
LAN network, access your HAMlab and arrange the Access Point mode. After this there is no need for
LAN network and after restarting the HAMlab the settings are saved.
Note
Connecting the HAMlab via Access Point mode the additional WiFi dongle is needed. WiFi dongle is
available [Link to RS or similar].
How to create Access Point network and connect to it is describe below.
1. Start your HAMlab web user interface (Use connection described Local Area Network (LAN)
connection )
2. Open Network Manager application
3. Input the name and password of the Access Point network to be created (Password name
should be at least 8 characters long. Do not use special signs.)
4. Connect your PC/Laptop/Tablet/Phone to the network created by HAMlab
5. Input Access Point network IP address to the web browser URL field and press enter.
The manual is made on the site
Red Pitaya HAMlab Documentation
https://trcvr.ru 24