Red Pitaya HAMlab 80-10 10W User Manual page 38

INPUTS: On the right side of the Oscilloscope&Sig. Generator application interface the IN1 and IN2
channels are listed. By a simple click on the name of a channel (not the gear) the channel gets
highlighted and you can simply control all the settings of the respective channel.
The available settings are the following:
SHOW: Shows or hides the curve associated with the channel.
INVERT*: Reflects the graph on the X axis.
Probe attenuation: The division that was set on the probe. (must be
selected manually)
Vertical offset: Moves the curve up or down.
LV and HV: Are oscilloscope input range options of your HAMlab
implemented via attenuator.

HV represent higher voltage range from -20 to +20 V.

LV represent low voltage range from -1 to 1 V.
AC and DC coupling: HAMlab enables you to measure signals in two coupling modes AC and DC.

AC Oscilloscope will show only AC component of a signal.

DC Oscilloscope will show both AC and DC components of a signal.
3.1.2. Output
On the right side of the Oscilloscope & Sig. Generator application interface the OUT1 and OUT2 channels
are listed.
By a simple click on the name of a channel (not the gear) the channel gets highlighted and you can
simply control all the settings of the respective channel.
The available settings are the following:

ON,

SHOW,

Type,

Trigger,
The manual is made on the site
Red Pitaya HAMlab Documentation
https://trcvr.ru 38