4. At the end of the installation you are asked if you want to run PowerSDR software immediately,
feel free to do so.
5. PowerSDR software will start with the calculation of the FFT wisdom file, which will take a while
depending on the CPU power of your computer. This is only done once, even after updating the
software to a new version in the future:
6. After starting the PowerSDR software you will be led through the PowerSDR software specific
setup wizard which lets you configure the software to use it with your STEMlab. Pick the
HAMlab/STEMlab radio model.
The manual is made on the site
Red Pitaya HAMlab Documentation
https://trcvr.ru
51