Red Pitaya HAMlab 80-10 10W User Manual page 65

5.1.1. Highlights
Architecture:
Band coverage:
Transmit power:
Wideband Frequency Coverage:
Connection to PC:
Software:
Phones and MIC connection:
Secondary Rx and Tx channel:
CW key and paddle input:
5.1.2. Receiver Specifications
Architecture:
ADC Sampling Rate:
ADC Resolution:
Wideband Frequency Coverage:
MDS (min. detectable signal):
Preamp OFF at 14MHz
Preamp +15dB at 14MHz
Preamp +30dB at 50MHz
Preselectors:
5.1.3. Transmitter Specifications
Architecture:
TX DAC Sampling Rate:
TX DAC Resolution:
RF Output Power:
Transmitter Frequency Range:
Low Pass PA Filter Bands:
Emission Modes Types:
Harmonic Radiation:
3rd-Order IMD:
Cooling:
Note
C25 also supports 6m operation and has all necessary output filters for 6m, anyhow STEMlab 125-14
ouput signal is not pure enough to comply harmonic regulations for 6m
5.1.4. General Specifications
Antenna Connector:
Antenna Impedance:
RF Output Power:
Maximum Interconnect Cable
Length Ethernet:
Power connector:
The manual is made on the site
Red Pitaya HAMlab Documentation
5. HAMlab 160-6 10W Specifications
5.1. SDR specifications
direct sampling / internal high performance 14-bit A/D and D/A 125 Msps
converters (no sound card required)
All band receiver and 160-6m transmitter
up to 10 W
25 kHz - 62.25 MHz
1 Gbit Ethernet or WIFI connection
Power SDR HAMlab edition
available on the front panel
available through back panel BNC connectors (RX2 IN, XVTX)
available through front panel jack connector
Direct Digital Sampling
125Msps
14 bits
25 kHz - 62.25 MHz
MDS (typ)@ 500Hz BW
-113dBm
-130dBm
-135dBm
More MDS measurements.
Available as add-on module (coming soon)
User can also connect own preselectors/filters
Direct Digital Up-conversion
125 Msps
14 bits
up to 10 W CW and SSB at @ 13.8 V input voltage (max. 15 V)
160 - 10 m (amateur bands only)*
160m / 80 m / 40 m / 30m / 20 m / 17m / 15m / 12m / 10m / 6 m
(possibility to changed it to any range 1.8 - 50 MHz)
A1A (CWU, CWL), J3E (USB, LSB), A3E (AM), F3E (FM), DIGITAL (DIGU, DIGL)
DIGITAL (DIGU, DIGL)
better than -45 dB
better than -35 dB below PEP @ 14.2 MHz 10 Watts PEP
copper heat spreader
ANT1 and ANT2 available on SMA connectors Included one cable
with SMA to SO-239 UHF
50 Ohm Unbalanced
up to 10 W CW and SSB at 13.8 V input voltage (max. 15 V)
100 meters (328 feet), Category 5 cable
PowerPole
https://trcvr.ru 65