3.4.1.1. Power SDR configuration
Audio configuration (only required for HAMlab 80-10 10W model)
3.4.1.2. Power SDR basic usage
3.4.1.2.1. Putting HAMlab into SDR mode
1. Turn on power supply, HAMlab will start automatically. Next time you can momentary press on
the power button to turn it on/off.
2. Make sure your computer is connected to same local area network as HAMlab.
3. On your computer start a WEB browser (Chrome recommended).
4. Type in the HAMlab URL that can be found on the back panel of the HAMlab
The manual is made on the site
Red Pitaya HAMlab Documentation
https://trcvr.ru
53