Siemens SITRANS F Series Operating Instructions Manual page 23

6. Insert AC or DC power wires into wire entry holes and secure by tightening wire clamp
7. Pull sensor cables through transmitter case cable gland and connect to the appropriate
8. Connect the power cables to the appropriate power source (100-240 VAC @ 50/60 Hz or
9. If unit is operational, turn power off, close Keypad Enclosure Cover and secure the six
10. Turn power on. Within 10 seconds of power-up the transmitter 2-line LCD display screen
FST020 IP65 NEMA 4X
Operating Instructions, 02/2012, A5E03086487-05
screws.
Note
Power supply connector wires should be stripped stranded or solid conductors AWG 12 -
18.
UP and DOWN sensor connectors.
11.5-28.5 VDC) and power up unit.
WARNING
The branch circuit must be limited to 20A. It is recommended that the circuit breaker be
located near the transmitter.
WARNING
Shock Hazard
Disable power before servicing fuse F1.
cover screws (torque to 6 in-lbs).
Note
Do not position the transmitter in such a way that it is difficult to operate the circuit
breaker or the disconnection device.
will appear.
①
Power-up 2-Line LCD Display Screen
Connecting
5.1 Transmitter Wiring
21