Replacement Procedure For Analog Kvm Switch - Fujitsu KVM0108A User Manual

Replacement procedure for analog KVM switch

(working time: 30 minutes)
Tools Required (not provided)
Phillips Screwdriver
＊After replacement work of KVM switch, System administrator will need to reconfigure.
Refer to "On Screen Display (OSD) Operation (Page 14)" for setting method.
1. Remove the cables other than the power cord connected to the KVM switch to be replaced.
There is no need to power off on the server.
(To disconnect and reconnect the KVM adapter cable on the server, it is necessary to power
off.)
2. Remove the power cord connected to the KVM switch to be replaced.
3. Remove the two screws on each side of the mounting bracket and remove it from the rack.
*Note：Please remove screws while supporting firmly so as not to drop at the time of removal.
4. If mounting on the back of the rack, remove the mounting bracket from the KVM switch.
5. Install the replacement KVM switch in the rack.
For mounting on the front of the rack, refer to "Rack mounting (page 7)".
For mounting on the back of the rack, refer to "Rack mounting - Rear (page 8)" .
For the mounting bracket, use the bracket removed in [Procedure 4].
6. Connect the cable removed in [Procedure 1] to the KVM switch.
7. Connect the power cord to the KVM switch and boot up the KVM switch.
(For the power cord is connected, the power turns on automatically and boot up the KVM switch.)
8. Confirm that the connected server can be referred to from the OSD of the KVM switch.
Initial user name : admin
Initial password : admin
9. In case of multiple hierarchical structure, reset the station ID.
∟Top view of OSD
∟F4:ADM
∟Select "RESET STATION IDS"
∟Execution
For details, please refer to "Reset Station IDs (page 20)".
10. For changing the setting of the KVM switch from the initial value, set the KVM switch.
(System administrator work) Please refer to "On screen display (OSD) operation (page 14)" for
setting method.
13