Accessory Inventory - Fujitsu KVM0108A User Manual

Analog kvm switch

Hide thumbs

Table Of Contents

Table of Contents

INJURY OR EQUIPMENT DAMAGE

• Do not connect the RJ-11 connector marked "UPGRADE" to a public

telecommunication network.

• Before working on the rack, make sure that the stabilizers are secured to the rack,

extended to the floor, and that the full weight of the rack rests on the floor. Install

front and side stabilizers on a single rack or front stabilizers for joined multiple

racks before working on the rack.

• Always load the rack from the bottom up, and load the heaviest item in the rack

first.

• Make sure that the rack is level and stable before extending a device from the rack.

• Use caution when pressing the device rail release latches and sliding a device into

or out of a rack; the slide rails can pinch your fingers.

• After a device is inserted into the rack, carefully extend the rail into a locking

position, and then slide the device into the rack.

• Do not overload the AC supply branch circuit that provides power to the rack. The

total rack load should not exceed 80 percent of the branch circuit rating.

• Make sure that all equipment used on the rack, including power strips and other

electrical connectors, is properly grounded.

• Ensure that proper airflow is provided to devices in the rack.

• Ensure that the operating ambient temperature of the rack environment does not

exceed the maximum ambient temperature specified for the equipment by the

manufacturer

• Do not step on or stand on any device when servicing other devices in a rack.

• Do not place the device on an unstable surface. If the device falls, serious damage

will result.

• Do not block ventilation openings. Overheating of internal components may occur.

• Route the power cord and cables so that they cannot be stepped on or tripped

over.

Failure to follow these instructions can result in injury or equipment damage.