Fujitsu KVM s3-1621 Quick Installation Manual

The following instructions will help you install
and use your KVM s3-1621 .
Should you require further assistance, please
consult your installer/user guide.
Connecting power to the switch
1
Power down all servers that will be part of your
switching system. Locate the power cord that came with
the switch. Plug one end into the power socket on the
rear of the switch. Plug the other end into an appropriate
AC wall outlet.
Connecting the local port.
2
Plug your VGA monitor, PS/2 or USB keyboard and mouse
cables into the appropriately labeled switch ports.
Connecting a KVM-IA to the switch
3
Choose an available port on the rear of your switch. Plug
one end of a CAT 5 cable (4-pair, up to 10 meters) into
a numbered port and plug the other end into the RJ-45
connector of a KVM-IA.
Connecting a server to the KVM-IA
4
Plug the KVM-IA into the appropriate ports on the back
of the server. Repeat this procedure for all servers that
are to be connected to the switch.
Connecting network and remote users
5
Plug a CAT 5 cable from your Ethernet network into the
LAN connector on the back of your switch. Network
users will gain access through this port.
Connecting local virtual media
6
(optional)
Connect virtual media devices to any of the four USB
ports on the switch.
Powering up targets and switch
7
Power up each target server and then power up the
switch.
NOTE: To open a virtual media session with a server, the
server must fi rst be connected to the switch using a virtual-
media capable KVM-IA. (KVM s3-Adapter USB2-VGA).
Fujitsu Technology Solutions GmbH, User Documentation, 33094 Paderborn, Germany • Email - manuals@ts.fujitsu.com • Online - http://ts.fujitsu.com/support
All hardware and software names used are trademarks of their respective manufacturers.
installation
Quick Installation Guide
KVM s3-1621
Power down all
servers and attach
the appropriate
power cord to the
switch.
5
Connect the switch to
the network. Local Connections
For additional information
For further instructions on switch connection, software
setup and security confi guration, please refer to the
installer/user guide included with the switch. Check
http://www.fujitsu.com for the latest switch software and
fi rmware updates.
1 2
Plug in the keyboard,
monitor, mouse and USB
connectors for your local
connection.
Server
Server
2
KVM s3-1621
3
Connect KVM-IA
adapters to the
switch.
Server
Server
4
Connect servers to the
KVM-IA adapters.
590-592-609B