Fujitsu KVM0108A User Manual page 28

Set Accessible Ports
Edit Port Names
Restore Default Values This function will undo all changes and return the setup to the original factory default
Clear the Name List
Reset Station IDs
Set Operating System
Set Cat 5 Length
Set Keyboard Language Sets the keyboard language layout for the server attached to each port. Press [
Firmware Upgrade
Adapter Upgrade
Set Login Mode
20
This function allows the administrator to define user access to the servers on the installation on
a port-by-port basis.
For each user, select the target port, then press the [Spacebar] to cycle through the choices: F
(Full Access), V (View Only), or N (No Access). Repeat until all access rights have been set,
then press [ ]. The default is F for all users on all ports.
E
SC
Note: An "N" setting means that no access rights are granted. The port will not show up on the
user's list on the Main Screen.
To identify which server is attached to a particular port, every port can be assigned a name.
This function allows the administrator to create, modify, or delete port names.
To assign a port name: Click on the port, or use the navigation keys to move the highlight bar
to it, then press [ENTER].
When you have finished editing, press [ENTER] to have the change take effect. To abort the
change, press [ESC].
The username and password may be up to 15 characters long.
The following characters are allowed : A-Z 0-9 ():+-/:?,.[ ]
settings except for the account and port names settings that were assigned to the ports.
This function clears the port name list.
This function directs the OSD to re-scan the station positions of the entire installation and
updates the OSD so that the OSD station information corresponds to the new physical layout.
OS of the server attached to each port. You must configure each port on the installation. For
each port, press the [
S
PACEBAR
until all the ports have been set, then press [
Note: A Sun or Mac computer may not boot when you run it for the first time unless the
correct operating system is set for the port to which it is connected.
Lets you specify how long the Cat 5e/6 cable between the port and the KVM adapter cable is.
Press [ ] to cycle through the cable length settings:
S
PACEBAR
• S: Short - for up to 25 m
• M: Medium - for between 20 and 35 m
• L: Long - for above 35 m
An S, M, or L appears next to the port to indicate the choice.
cycle through the choices. The default is English (US).
Unused in this device.
If Firmware Upgrade Utility is enable, press reset switch to reboot the derive. In case
of chained tiering connections. it is necessary to reboot all device.
Unused in this device.
If Firmware Upgrade Utility is enable, press reset switch to reboot the derive. In case
of chained tiering connections. it is necessary to reboot all device.
This function allows the administrator to request users to login or not. When the login dialog
box is disabled, the system disables the login/ logout function. If the system is re-started, the
login/logout function remains disabled.
] to cycle through the choices (WIN, Mac or Sun). Repeat
]. The default is WIN. (WIN:Windows OS)
E
SC
] to
S
PACEBAR