Ambient Requirements; Installing Rdu-Sic G2 Card - Emerson Liebert Vertiv RDU-SIC G2 User Manual

The jumper setting of the RDU-SIC G2 card is normal mode by default.

2.1.2 Ambient Requirements

Operation environment
The RDU-SIC G2 must be installed indoor. Refer to Table 1-5 for specific requirement.
ESD-proof
To make the static electricity reduce to zero, you must take measures as follows:
Keep proper temperature and humidity in the data center (see Table 1-5).
Wear the ESD-proof gloves and work clothes before contacting with the PCB. If there are not ESD-proof gloves
and work clothes, wash hands with water and dry them.
Immunity
Take the following measures for immunity:
Keep the working ground of RDU-SIC G2 away from earthing device of electricity device or SPD earthing device
Keep away from the radio-transmitting station, radar transmitter and high-frequency large-current device
Use the electromagnetic shielding method if necessary

2.2 Installing RDU-SIC G2 Card

1. Set the jumpers of the RDU-SIC G2 card according to Table 2-1.
2. Insert the RDU-SIC G2 card into position along the guide grooves on both sides of the intellislot intelligent slot, and
tighten the screws.
3. Open the power device. At this point, if the RUN indicator (yellow) of the RDU-SIC G2 card turns on, it indicates that
the RDU-SIC G2 card is starting up.
RDU-SIC G2 Card User Manual
Chapter 2 Hardware Installation 5