Emerson Liebert Vertiv RDU-SIC G2 User Manual page 29

Chapter 3 Web Page Of RDU-SIC G2 27
Click the Network Setting under the System Options menu, and then click the Access Management tab, the page
shown in Figure 3-46 pops up.
Figure 3-46 Access management
In the event of adding visitor, in the textbox of IP Address of RDU Manager, type the new IP address of the RDU
manager, and click the Add Visitor button to finish the configuration.

Note
1. Up to three RDU manager IP addresses can be added in the system.
2. In the event of adding visitor, if you select to use an agent, you also need to configure the agent server.
3. SNMP Configuration
Click the Network Setting under the System Options menu, and then click the SNMP Configuration tab, you can
configure SNMP agent. The RDU-SIC G2 system supports V2 and V3 versions of SNMP agent.
As shown in Figure 3-47, the specific setting method of SNMP V2 is as follows:
1) Set NMS IP (host IP address of SNMP agent data receiving end);
2) Set Trap Level: 'Enable' or 'disable';
3) Keep defaults for other items.
Figure 3-47 SNMP V2 setting
As shown in Figure 3-47, the specific setting method of SNMP V3 is as follows:
1) Set NMS IP (host IP address of SNMP agent data receiving end);
2) Set the Trap Level: 'Enable' or 'disable';
3) Set the Name;
RDU-SIC G2 Card User Manual