Emerson Liebert Vertiv RDU-SIC G2 User Manual page 26

24 Chapter 3 Web Page Of RDU-SIC G2
Click the Browse... button to download configure package (file format of .iru) from local content, and click the Install
button to install the new device type.

Note
The device type number supported by the system is related to the system remaining memory and the size of driver configuration
package, but the number cannot exceed 64.
The page displays the installed device type information in the lower right part. Click the Uninstall button, the
confirming dialog box pops up, as shown in Figure 3-40.
Click OK, the dialog box of Security authentication pops up, as shown in Figure 3-13, type the login password of
current user, and click OK to uninstall the corresponding equipment type.

Note
1. While installing device type, if the device type exists and the device driver has a higher version than the driver to be added, it
cannot be installed repeatedly;
2. If the installation pack has no version information, or the version information does not match the software version, the device
type cannot be installed.
2. If some device uses the device type, the Uninstall button becomes gray, displaying Using, and the device type cannot be
uninstalled.
Signal Setting
Click the Signal Setting under the Device Options menu, the page shown in Figure 3-41 pops up.
Figure 3-39 Install/Uninstall Device Type
Figure 3-40 Confirming dialog box
RDU-SIC G2 Card User Manual