Emerson Liebert Vertiv RDU-SIC G2 User Manual page 24

22 Chapter 3 Web Page Of RDU-SIC G2
As shown in Figure 3-35, you can add/modify/delete a new device, the procedures are as follows:
Adding a new device
1) Choose the device type in the Device Type textbox;
2) Type the device name in the Device Name textbox, or use the default device name;
3) After the device type is chosen, the drop-down box of Port will list the default port number(s) of the device type
automatically; if the device type is not chosen, the port number cannot be chosen;
4) Type the device address, which must be numbers from 1 to xx, in the Device Address textbox. The device
addresses under the same port number must be different; for some device types, you need not type the device
address, at this point, the Device Address textbox turn gray and cannot be edited. When one kind of device has many
models, you need to type the model ID, which must be numbers from 1 to xx. The model IDs under one kind of device
must be different;
5) Choose or type the device location;
6) Type the communication parameter in the Parameter textbox. In the event that the device type is certain, the
communication parameter prompt information will appear in the Parameter textbox, including the communication
parameter format and default communication parameter of the equip type;
7) Click the Add button, the page shown in Prompt information 1 in Figure 3-36 pops up, at the same time, a piece of
new device information will be added in the device list;
8) Click the Save Configuration button, the page shown in Prompt information 2 in Figure 3-36 pops up;
If clicking the Cancel button, the added equipment fails; if clicking OK, the dialog box of Security authentication pops
up, as shown in Figure 3-13.
9) Type the login password of current user, and click OK. The reboot page pops up, as shown in Figure 3-37;
Figure 3-35 Add/modify/delete equipment
Prompt information 1
Prompt information 2
Figure 3-36 Prompt information
RDU-SIC G2 Card User Manual