Indicator Lights; Cook/Filter Switch And Power On Switch - Broaster 1600 Service Manual

INDICATOR LIGHTS

There are three indicator lights on the con-
trol panel. Indicator lights will illuminate
respectively when the POWER ON switch is
on, COOK/FILTER switch is in COOK posi-
tion and unit is heating and when the pres-
sure regulating valve is CLOSED.
Replacement:
1. See ACCESS FOR SERVICE.
2. Disconnect wires.
3. Push down on light fixture (3,5 & 8)
located behind the control panel. Slide
fixture toward the wire end of fixture
until amber lense (10) is free of fixture.
4. Install new light in reverse order. Be
sure all wire connections are secure
and in their original location.
COOK/FILTER SWITCH AND
POWER ON SWITCH
1. See ACCESS FOR SERVICE.
2. Check all terminals and wire connec-
tions. Refer to wiring diagram.
3. Turn switch to COOK or ON position.
4. With needle nose pliers, disconnect
center terminal from switch.
5. Check across center terminal and
lower terminal with an ohmmeter.
Meter should indicate a closed circuit.
If not, switch is faulty.
6. Turn switch to FILTER or OFF.
7. Check across center terminal and
upper terminal with an ohmmeter.
Meter should indicate a closed circuit.
If not, switch is faulty.
Replacement:
1. See ACCESS FOR SERVICE.
Continued:
3 - 3
Manual #13898 2/00 Rev 9/11