Commissioning Of Multi-Cabinet Configuration; System Display; Graphical Display Operation - ABB Conceptpower DPA 500 User Manual

7.3

Commissioning of Multi-Cabinet Configuration

THE OPERATIONS DESCRIBED IN THIS CHAPTER MUST BE PERFORMED BY A SERVICE
ENGINEER FROM THE MANUFACTURER OR BY AN AGENT CERTIFIED BY THE
MANUFACTURER.
WARNING!
Before commissioning a Multi-Cabinet Configuration verify that:
1. All the input and output cabling has been performed correctly according to Section 5 of this User Manual;
2. The parallel communication cables have been connected correctly according to Section 7.2.2.
3. All the DIP Switches for the Modules and Conceptpower DPA Cabinets been set correctly according to Section 7.2.2, 7.2.3, and
7.2.4.
4. All the internal (if any) and/or external battery cabinets/racks have been connected correctly.
7.4

System Display

ONLY PERSONS THAT HAVE BEEN TRAINED BY SERVICE TECHNICIANS OF THE
MANUFACTURER OR CERTIFIED SERVICE PARTNERS ARE ALLOWED TO OPERATE ON THE
CONTROL PANEL WITH CLOSED DOORS.
ALL OTHER INTERVENTIONS ON THE UPS SYSTEM HAVE TO BE DONE ONLY BY SERVICE
WARNING!
TECHNICIANS OF THE MANUFACTURER.
The user-friendly, touchscreen graphical display on the system level offers the opportunity of directly monitoring the system status as well
as the status of each individual module. The graphical display additionally provides all the measurements (module and system level) and
the user is able to transfer from INVERTER to BYPASS and vice-versa. All other commands must be performed on the DPA display. With
both displays in place (module and system level), the UPS offers full user friendliness without making compromises on robustness.
Figure 16: System Display
7.4.1

Graphical Display Operation

For simple operation and configuration, the UPS is optionally delivered with a microprocessor-based touchscreen display. The navigation,
procedures and the features of the display are detailed in subsequent sections.
 The touchscreen display enables the operator to perform the following:
 Check operational status and measurements
 Execute operational commands
 Monitor the power flow through the UPS system
 Check events and alarm history
 Silence alarms
 Adjust programmable parameters
32 Conceptpower DPA 500 480V UL │94-12-043275 A02