Commissioning Of Multi-Cabinet Configuration; Start-Up Of A Multi-Cabinet Configuration; Shutdown Of Multi-Cabinet Configuration; System Display - ABB Conceptpower DPA 500 User Manual

6.3 COMMISSIONING OF MULTI-CABINET CONFIGURATION

WARNING!
6.3.1

Start-up of a Multi-Cabinet Configuration

Before starting up a Multi-Cabinet Configuration verify that:
1. All the input and output cabling has been performed correctly according to section 4.3 of this User Manual;
2. The parallel communication cables have been connected correctly according to Paragraph 1.2.2
3. All the DIP Switches for the Modules and CONCEPTPOWER DPA
according to Paragraph 1.2.3
4. All the internal (if any) and /or external battery cabinets/racks have been connected correctly
Start the system as described subsection 6.7
6.3.2

Shutdown of Multi-Cabinet Configuration

Before shutting-down of a Multi-Cabinet Configuration make sure that the loads do need power protection and
that they are disconnected.
The UPS may be shut down completely if the loads do not need any power supply. Therefore the
!
steps in this Paragraph are to be performed only after the load has been disconnected and does
not need any power supply.
To perform a complete shutdown of a Multi-Cabinet Configuration proceed as described in the shutdown
procedure described in section 6.8

6.4 SYSTEM DISPLAY

WARNING!
The user-friendly, touchscreen graphical display on the system level offers the opportunity of directly monitoring the
system status as well as the status of each individual module. The graphical display additionally provides all the
measurements (module and system level) and the user is able to transfer from INVERTER to BYPASS and vice-
versa. All other commands must be performed on the DPA display. With both displays in place (module and system
level), the UPS offers full user friendliness without making compromises on robustness.
THE OPERATIONS DESCRIBED IN THIS CHAPTER MUST BE
PERFORMED BY A SERVICE ENGINEER FROM THE MANUFACTURER
OR FROM AN AGENT CERTIFIED BY THE MANUFACTURER.
ONLY PERSONS WHICH HAVE BEEN TRAINED BY SERVICE
TECHNICIANS OF THE MANUFACTURER OR HIS CERTIFIED SERVICE
PARTNERS ARE ALLOWED TO OPERATE ON THE CONTROL PANEL
WITH CLOSED DOORS.
ALL OTHER INTERVENTIONS ON THE UPS SYSTEM HAVE TO BE DONE
ONLY BY SERVICE TECHNICIANS OF THE MANUFACTURER.
Figure 16: System display
04-3275_OPM_ABB_CONCEPTPOWER_DPA_500kW_EN_REV-A.docx
Modifications reserved
TM
- Cabinets been set correctly
Page 35/78 ABB