Perlick SIGNATURE Series Product Manual page 25

PERLICK RESIDENTIAL ICE MAKER MANUAL
17. Replace the slope in its correct position. See Fig. 39.
Slope
18. Discard the sanitizing solution.
19. Mix a new batch of the sanitizing solution and slowly
pour it into the water tank.
20. Move the control switch to the "WASH" position.
21. After circulating the sanitizing solution for 15 minutes,
move the control switch to the "OFF" position.
22. Disconnect the suction tube. Allow the water tank to
drain, then reconnect the suction tube.
23. Repeat steps 19 through 22 one time.
24. Move the control switch to the "ICE" position and
allow the icemaker to operate for 2 minutes.
This allows the water tank to fill with water.
25. Move the control switch to the "WASH" position.
26. Allow the water to circulate for 5 minutes, then move
the control switch to the "OFF" position.
27. Disconnect the suction tube. Allow the water tank to
drain, then reconnect the suction tube.
28. Repeat steps 24 through 27 two more times to rinse
thoroughly.
29. Clean the storage bin liner, door liner, and door gasket
with a neutral cleaner. Rinse thoroughly after cleaning.
30. Move the control switch to the "ICE" position to start
the automatic ice making process.
Fig. 39
MAINTENANCE
STAINLESS STEEL EXTERIOR
To prevent corrosion, wipe the exterior occasionally with a
clean and soft cloth. Use a damp cloth containing a neutral
cleaner to wipe off oil or dirt build up.
STORAGE BIN DRAIN
In some conditions, slime may build up inside the storage bin
drain and prevent water from draining properly. To prevent this
buildup, perform the following procedure once every 3 months
or as often as necessary for conditions.
WARNING
water could build up in the bin and overflow, leading to costly
water damage.
1. Move the control switch to the "OFF" position
DANGER
!
touch the control switch with damp hands.
2. Remove all ice from the storage bin.
3. Mix a batch of sanitizing solution by diluting
1.25 fl.oz. (37 ml or 2.5 tbs) of a 5.25% sodium
hypochlorite solution (chlorine bleach) with
2.5 gallons (9.5 l) of warm water. Using a chlorine test
strip or other method, confirm that you have a
concentration of about 200 ppm.
CAUTION
the solution immediately after dilution.
4. Slowly pour the sanitizing solution into the
storage bin.
5. After all of the solution has drained, clean the storage
bin liner with a neutral cleaner. Rinse thoroughly with
clean water.
6. Move the control switch to the "ICE" position to start
the automatic ice making process.
If the storage bin drain becomes clogged,
To reduce the risk of electric shock, do not
For safety and maximum effectiveness, use
perlick customer service (800)558-5592 | 25