18” shallow-depth series beverage center/48” signature series refrigerator / wine reserve stacked on a 48” signature series freezer / refrigerator drawers (12 pages)
If you do not complete the Warranty Registration provide the highest level of customer satisfaction. online or return via US mail, Perlick will use the If, however service is required, call Perlick at date of sale as the fi rst date of warranty for the 1-800-558-5592.
Indicates a hazard where CAUTION information is important for the safe and effi cient minor injury or product installation, operation and care of your Perlick unit. damage may occur if precautions are not Indicates a hazard that WILL followed. DANGER result in serious injury or death if precautions are not followed.
Signature Series Installation Manual • Never use extension cord to connect Failure to comply with these DANGER power to the unit. electrical guidelines may result in possible death or serious injury, fi re, • If a 2-prong receptacle is encountered, or...
Page 5
Signature Series Installation Manual 1. Make sure the space opening is correctly shimmed height. Using an adjustable wrench sized for the unit. See Specifi cations on or pliers, turn legs clockwise to lower the unit page 11 for correct dimensions and electrical or counterclockwise to raise it.
Page 6
Figure 3. Toe Plate Installation Figure 4. Shelving/Drawer Adjustment Shelving/Drawers Adjustment Door Options See Figure 4. Perlick residential units offer a variety of door Completely empty shelf or CAUTION panel design alternatives; solid stainless steel, drawer before removing. solid wood overlay, glass with stainless steel trim 1.
Page 7
Signature Series Installation Manual All Perlick units accept any of the above door confi gurations and are fully interchangeable. NOTE: Glass with stainless steel trim and glass with wood trim may sweat in conditions with relative humidity over 75%. Changing Door Swing Direction...
Page 8
6 (Figure 12). 8. Remove the Perlick nameplate from the door 12. Place lower V-block into lower cabinet hinge front using plastic putty knife (Figure 10). with notch parallel to cabinet (Figure 13).
Page 9
Signature Series Installation Manual Bearing in door top hinge bracket Door bottom bracket 6° Orientation V-block V-block parallel to cabinet BOTTOM VIEW TOP VIEW Figure 13. Installing V-Block Figure 11. Bearing and V-Block Top hinge and screws Bottom hinge and screws...
Signature Series Installation Manual OPTIONAL EQUIPMENT Handle Installation Mounting bracket Handle mounting on wood CAUTION overlay door should be Lock strike mounted on overlay panel only (not the door) to avoid damage to the factory door. Lockwasher 1. Handle must be attached to overlay before Lock body mounting overlay onto door.
Signature Series Installation Manual tighten mounting screws securely. Install 1/8” x 0.312” deep the rest of the mounting screws and tighten securely. 5/8” 8” 1-17/32” 7-1/4” Do not overtighten wood CAUTION 5/16” overlay attachment screws as this may damage the factory supplied door frame.
Third through Sixth Year Limited Parts Only Warranty. TERMS: The Perlick Warranty applies to products installed in the fi fty United States, the District of Columbia or the ten provinces of Canada. All service provided by Perlick Corporation under the above warranty must be performed by authorized Perlick service representatives, unless otherwise specifi ed by Perlick.
Page 16
8300 West Good Hope Road • Milwaukee, WI 53223 • Toll Free 800.558.5592 • Fax 414.353.7069 • www.bringperlickhome.com...