Sierra Wireless FX30 User Manual page 17

Rev 4 March 2019
To attach the compatibility bar to the bracket:
1. Note the large and small raised tabs on the bracket. Each tab has a small
hole in the center of the raised portion. Also note the large and small rectan-
gular openings in the compatibility bar. See
Mounting bracket
Small raised tab
with small hole
Figure 2-9: Mounting bracket and compatibility bar
2. Orient the mounting bracket and the compatibility bar as shown in
Figure 2-10.
Figure 2-10: Mounting bracket and compatibility bar orientation
3. Place the compatibility bar on top of the bracket, so that the tabs on the
bracket are inside the openings in the bar, and slide the bar into place. When
fully secure, the knobs on the bar should be inside the small holes on the tabs.
Small raised knobs
Large raised tab
with small hole
17
Installation and Startup
Figure 2-9.
Large opening
Small opening
Compatibility bar
41110030