Wiring Diagrams - Sierra Wireless FX30 User Manual

Rev 4 March 2019

Wiring Diagrams

In the following diagrams, FX30 refers to either FX30 and FX30S.
Always On Installation
For an Always On application, connect the wires as shown in
DC power source
DC power source
Figure 2-15: Always on installation
• Pin 1 (Power)—Use the red wire in the DC cable to connect Pin 1 to the
power source.
• Pin 2 (Ground)—Use the black wire in the DC cable to connect Pin 2 to
ground. See also Step 2—Mount and Ground the FX30 Chassis
• Pin 3 (On/Off)—Connected to power
• Optional—I/O 1, I/O 2, and I/O 3
Note: See Table D-1, FX30 Hardware Feature to Linux Interface Mapping,
the radio module GPIO and Linux interface mapping of pin 3, I/O 1, I/O 2, and I/O 3.
On/Off Installation
For an On/Off application, connect the wires as shown in
Figure 2-17.
DC power source
DC power source
On/Off switch
On/Off switch
Figure 2-16: On/Off Installation with switch
• Pin 1 (Power)—Use the red wire in the DC cable to connect Pin 1 to the
power source.
• Pin 2 (Ground)—Use the black wire in the DC cable to connect Pin 2 to
ground. See also Step 2—Mount and Ground the FX30 Chassis
23
FX30
Gateway
1 Power
1
Power
3 On/Off
3
On/Off
I/O 1
I/O1
I/O 2
I/O2
I/O 3
I/O3
2 Ground
2
Ground
FX30
Gateway
1 Power
1
3 On/Off Power
I/O 1 On/Off
3
I/O 2
I/O1
I/O2
I/O 3
I/O3
2 Ground
2
Ground
Installation and Startup
Figure 2-15.
on page 12.
on page 74 for
Figure 2-16 or
on page 12.
41110030