Table of Contents
Advertisement
4. Adjust the left paper guide to the desired left position by moving it
horizontally in either direction.
Figure 7-8. Adjust the paper guides to accommodate the width of the paper.
5. Adjust the right paper guide to accommodate the width of the paper.
The guides should be adjusted to restrict the amount of horizontal play
while allowing the paper to slide up and down freely between the two
paper guides. The ideal distance between paper ream and paper guides is
0.25 mm (0.01") on both sides at the narrowest part of the paper guides.
6. Fan the paper stack and square it off properly before inserting it into the
Automatic Sheet Feeder.
I
Figure 7-9. Fan the paper before inserfing into the ASF.
7. Insert the paper stack into the Automatic Sheet Feeder.
The stack should not be more than 50 sheets of 20 lb paper.
If necessary, remove some sheets. The ASF may not perform satisfacto-
rily if it is overloaded.
69
Advertisement
Table of Contents
