Table of Contents
Advertisement
7. Open both tractor covers and mount the paper by aligning holes with the
pins on the tractor unit.
Tractor cover
mamp'ever
Figure
3-6. Mount the fanfold paper over the tractor units.
Adjust the spacing of the tractor units by sliding them along the bar, using
the clamp lever at the back of each unit to release and lock them in
position. When the clamp lever is up, the unit is released, and when it is
down, the unit is locked.
Now close the tractor covers, again making sure that the paper holes are
aligned with the pins on the tractor units. If they are not aligned properly,
you will have problems with paper feeding, possibly resulting in tearing
and jamming of the paper.
I
Figure 3-7.
Adjust the tractor positions to accommodate
the width of fanfold forms.
10.Close the rear cover and the mute cover, then set the paper guide in the
horizontal position, as shown in Figure 3-8. This will separate the printed
from the unprinted paper.
24
—
Advertisement
Table of Contents
