Table of Contents
Advertisement
Switch B-2: Paper-out
When this switch is OFF the printer ignores the paper-out detector and
prints down to (and beyond) the bottom edge.
Switch B-4: This switch is used for technical purpose only. Leave this
switch ON.
Switch B-5: Printable area
This printer can use two types of printing area format for single sheets
(cut forms).
By putting the switch ON ("Type A"), the top of the first lineof printing
will start 1/6inch from the top of the paper, and the printed area will end
1/6 inch from the bottom of the paper.
By putting the switch OFF ("Type B"), the first line of printing will start
at one inch from the top of the paper, and the printed area will end to
print 6 mm from the bottom of the printer.
Switches C-1 and C-2: Print Mode
These switches select the default print pitch and the fonts as shown
below.
Print Mode
c-1
c-2
10CPI DRAFT
ON
ON
IOCPI HS DRAFT
ON
OFF
17CPI DRAFT
OFF
ON
10CPI LQ
OFF
OFF
NOTE: If you change these switches after you have saved a macro,
these new settings will override the macro setting.
52
Advertisement
Table of Contents
