Star Micronics LC24-20 User Manual page 110

Set vertical tab stops
node ] ASCII I Decimal I Hexadecimal
I
<ESC> "B"
Both
Ill
fl~
27 66 nl 112 IB
42 nl n2
<t)>
0 00
Cancels all current vertical tab stops and sets new vertical tab stops
at lines
nl, n2,
etc., where
nl, n2,
etc. are numbers between 1 and
255. A maximum of 16 vertical tab stops can be set. The tab stops
must be specified in ascending order; any violation of ascending
order terminates the tab stop list. Standard termination is by the <0>
control code. The vertical tab stops are set in terms of the current line
spacing and do not move if the line spacing is changed later.
Set vertical tab stops every n lines
Mode Ascll Decimal Hexadecimal
Std.
<ESC> "e" < I > n
27
101 1 n
IB 65 01 n
Cancels all current vertical tab stops and sets new tab stops every n
lines. where
n is
between 2 and 127.
Set vertical tab stops in channel
Mode
ASCII Decimal Hexadecimal
Std.
<ESC> "b" II()
nl 27 98 no n/ IB 62
no
n]
d ,... <()> d 0
n2 00
Cancels all current vertical tab stops in channel M, (where nO is
between Oand 7) and sets new vertical tab stops in this channel. (A
channel is a set of vertical tab stops selected by the <ESC> "/"
command.) See <ESC> "B" for parameters
nZ, n2, ... <0>.
Select vertical tab channel
Mode ASCII
Decimal Hexadecimal
Std.
<ESC> "/"
no 27 47 no
IB 2F no
Selects a set of vertical tab stops designated by a channel number
(nO)from Oto 7. The tab stops in each channel are set by <ESC> "b".
102