Siemens FC121-ZA Technical Manual page 89

Message
Input
Input #
ACK
Input
Input #
External PSU fault
ACK
Reset
Active
EVAC
Active
EVAC sounder NL
Fault
EVAC Module
Input
Input #
Dependency reset
Test
Zone #
Fault
Input #
Alarm dialer fault
Input
Input #
SE ACK function
Fault
Output #
24VDC too low
Smart Infrastructure
Meaning
Panel has been acknowledged from input.
External PSU fault information received when get signal from input.
Panel has been acknowledged from panel.
Panel has been reset from panel.
All sounder outputs have been activated in quiescent mode, by pushing
the button 'SILENCE / RESOUND'.
Programmed EVAC sounder NL outputs have been activated by
pushing the button 'Start' on EVAC module.
With or without EVAC module status is not match with panel's
configure
Panel has been reset when get signal from input.
Zone # is in Test state.
The output 'Alarm dialer' is in fault state when get signal from input.
Panel has been acknowledged from input.
For output # which is powered by external power, external power
voltage is too low.
89
A6V10393190_h_en_--
2019-09-01