Siemens FC121-ZA Technical Manual page 12

12
Smart Infrastructure
Testing the product operability
l
Prevent the remote transmission from triggering erroneously.
l
If testing building installations or activating devices from third-party companies, you
must consult with the appointed people.
l
The activation of fire control installations for test purposes must not cause injury to
anyone or damage to the building installations. The following instructions must be
observed:
– Use the correct potential for activation; this is generally the potential of the
building installation.
l
Inform people before testing the alarm control devices and allow for possible panic
responses.
l
Inform people about any noise or mist which may be produced.
l
Before testing the remote transmission, notify the appropriate alarm and fault signal
receiving stations.
Modifications to the system layout and products
Modifications to the system and to individual products may result in faults, malfunctioning
and safety risks. Written confirmation must be obtained from Siemens and the
corresponding safety bodies for modifications or additions.
Modules and spare parts
l
Components and spare parts must comply with the technical specifications defined
by Siemens. Only use products specified or recommended by Siemens.
l
Only use fuses with the specified fuse characteristics.
l
Wrong battery types and improper battery changing lead to a risk of explosion. Only
use the same battery type or an equivalent battery type recommended by Siemens
(refer to Chapter 13).
l
Batteries must be disposed of in an environmentally friendly manner. Observe all
national guidelines and regulations.
Disregarding safety regulations
Before they are delivered, Siemens products are tested to ensure they function correctly
when used properly. Siemens disclaims all liability for damage or injuries caused by the
incorrect application of the instructions or the disregard of danger warnings contained in
the documentation. This applies in particular to the following damage or injury:
l
Personal injuries or damage to property caused by improper use and incorrect
application.
l
Personal injuries or damage to property caused by disregarding safety instructions
in the documentation or on the product.
l
Personal injury or damage to property caused by poor maintenance or lack of
maintenance.
Disclaimer
We have checked that the content of this document matches the hardware and software
described. Despite this, we cannot rule out deviations and therefore assume no liability
for them matching completely. The details in this document are checked regularly and
any corrections needed included in subsequent editions.
We are grateful for any suggestions for improvement.
A6V10393190_h_en_--
2019-09-01