Siemens FC121-ZA Technical Manual page 11

Smart Infrastructure
Safety–relevant instructions
National standards, regulations and legislation
Siemens products are developed and produced in compliance with the relevant
European and international safety standards. Should additional national or local safety
standards or legislation concerning the planning, assembly, installation, operation or
disposal of the product apply at the place of operation, then these must also be taken
into account together with the safety regulations in the product documentation.
Electrical installations
WARNING
Electrical voltage
Electric shock
Work on electrical installations may only be carried out by qualified electricians or by
instructed persons working under the guidance and supervision of a qualified
electrician, in accordance with the electro technical regulations.
l
Wherever possible disconnect products from the power supply when carrying out
commissioning, maintenance or repair work.
l
Lock volt-free areas to prevent them from being switched back on again by mistake.
l
Label the connection terminals with external voltage using a 'DANGER External
voltage' sign.
l
Route mains connections to products separately and fuse them with their own,
clearly marked fuse.
l
Fit an easily accessible disconnecting device in accordance with IEC 60950-1
outside the installation.
l
Produce earthing as stated in local safety regulations.
Assembly, installation, commissioning and maintenance
l
The panel is designed for operation in a closed room, please note the
environmental conditions in this technical manual.
l
Please check the country specific regulations and guidelines during installation and
programming of the fire control panel.
l
Only operate the fire control panel with housing closed due to the danger of an
electric shock.
l
If you require tools such as a ladder, these must be safe and must be intended for
the work in hand.
l
When starting the fire control panel ensure that unstable conditions cannot arise.
l
Ensure that all points listed in the 'Testing the product operability' section below are
observed.
l
You may only set controls to normal function when the product operability has been
completely tested and the system has been handed over to the customer.
11
A6V10393190_h_en_--
2019-09-01