Bosch Rexroth VCH 08.1 Manual page 98

96/117 Bosch Rexroth AG
Software
Obtain an IP address via DHCP
Specify an IP address
Visualization Data Source
Fig.9-6: Network settings
The network parameters are assigned automatically via DHCP.
The network parameters have to be configured manually.
The following data is necessary:
● IP Address:
Manual input of the IP address of the device.
● Subnet Mask:
Manual input of the Subnet Mask.
● Gateway:
Manual input of the gateway.
Fig.9-7: Visualization and communication settings
The visualization software can be filed locally on the IndraControl VCH 08.1 or
be filed on the control to be visualized.
● Control IP:
The IP address of the control to which the visualization interface should
be connected.
● Upload from Data Source:
DOK-SUPPL*-VCH*08.1***-PR02-EN-P
Rexroth IndraControl VCH 08.1 Hand-held Terminal