Warning Screens - Xavant STIMPOD NMS 410 Manual

1.5) Warning Screens

Insert Cable:
This is the first prompt which the user will encounter as the unit is switched on, and
signals that the unit is waiting for the cable to be inserted.
Cable not recognised:
This warning informs the user that the inserted cable is not compatible with the NMS
410/450X.
Open Circuit
Open Circuit Detected:
This warning informs the user that the two electrodes (i.e. ECG electrode and needle or
mapping device) do not form a closed circuit. This warning will be accompanied by a red
flashing LED, every time the unit attempts to stimulate.
Delay Active
Refractory Delay Active:
Once a TOF, DB, or PTC stimulation is performed, the refractory period timer is initiated.
During the countdown time it will not be possible to perform another stimulation. If
another stimulation is attempted, this warning screen will appear.
12
Insert Cable
Cable Not
Recognised
Detected
Refractory
Pause:
This warning informs the user that the PAUSE button was pressed.
The STIMPOD will pause all its activities and wait for the PAUSE button to be pressed again.
Replace Batteries
Replace Batteries:
This warning informs the user that the batteries are depleted beyond an acceptable
level. Continuing to operate the device thus will make it unreliable. To prevent this the
STIMPOD flashes this warning for 4 seconds before switching off.
Current Adjustment in NMT Mode:
When attempting to adjust the current while in NMT mode the device will show this
message, requesting the user to confirm the adjustment of the current.
Stimulation In
Stimulation in Progress:
Warning shown when the play button is pressed during stimulation.
Pause
Press Enter
To Confirm
Progress